A pressure sensor with a G1/4 thread and a stainless steel body, for measuring water pressure from 0 to 0.1 MPa (1 bar, roughly 10 metres of water head). It gives an analogue voltage of 0.5 to 4.5 V that your microcontroller can read. Sold per piece.
Specifications
| Thread | G1/4 |
|---|---|
| Body | Stainless steel |
| Pressure range | 0–0.1 MPa (0–1 bar) |
| Output | 0.5–4.5 V analogue |
| Connection | Three-wire cable (supply, ground, signal) |
| Sold as | Per piece |
Reading the output
Sensors of this type usually give 0.5 V at zero pressure and 4.5 V at full scale, in a straight line. Pressure is then about (voltage − 0.5) ÷ 4 × 0.1 MPa. Typical sensors of this type run from a 5 V supply, and a 5 V reading may need dividing down before it goes into a 3.3 V input. Confirm the supply voltage and the wire colours with a multimeter before connecting.
Typical uses
- Water level and tank monitoring
- Pump and pressure control projects
- Irrigation and plumbing monitoring
- Arduino and ESP32 data loggers
Notes. Specifications are taken from the supplier’s listing and typical figures for this type of part. Check the details you rely on before building them into a design.